![]() ![]() If a 0.4 mm nozzle is in use we can bevel by 0.2 mm per side. The size will depend on the print settings and what kind of border you are trying to create.A good starting point is a 45 degree bevel that measures half the diameter of the nozzle in use. We can open the stl file using a drawing program and create a small chamfer on the bottom of the print. ![]() Or you can act (if possible) directly on the model by modifying the design.The first way is by taking care to bring the nozzle back to the right height, and by intervening in one of the other ways described in the adhesion guide to ensure that the print remains well glued to the plate.In this case the elimination of elephant feet can be addressed in 3 ways. Obviously this can lead to the base (the first 2/3 layers) being slightly larger than the upper layers. Our advice was to bring the nozzle closer to the printing plate, to “spread” the first layer and ensure better adhesion. Generally, as also recommended in our guide of adhesion of the prints to the plate, we want to ensure that the print is well attached to the plate. That is, when the prints have the first layers larger than the layers above. This very exotic name, elephant foot, is nothing more than a definition of a rather common printing problem. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |